OTHER FEATURES
Presetting Starting Time
1. Press button (6). Memory location number
flashes.
Note: By repeatedly pressing button (6),
starting time 2 or 3 can be preset.
2. Press button (8) or (9) until correct startup
time is set.
3. Wait 5 seconds. Preset starting time is
stored and day of week flashes.
4. Press button (8) or (9) to select the correct
startup day of week.
5. Wait 5 seconds. The startup day of week is
stored.
The number of memory location remains on the
display. The timer is now in the programmed
mode and will switch the heater on at the preset
time.
Note: We recommend that memory locations 1
and 2 be used for presetting times within 24
hours of setting the timer. Memory location 3
can be used for a starting time within the next 7
days of setting the timer.
Recalling Preset Times
Press (6) repeatedly until the desired memory
location number and preset time are displayed.
Canceling Preset Time
Press button (6) repeatedly until no more
memory location number is visible on the
display.
Setting Operating Time
1. With heater off, press button (8). Operating
time flashes.
2. Press button (8) or (9) to set the operating
time (between 1 and 120 minutes)
3. Wait 5 seconds. Operating time is stored.
The heater remains in operation for the preset
time (except for continuous operation).
Setting the Remaining Operating Time
1. With heater in operation, press button (8).
Remaining operating time flashes.
2. Set remaining time with button (8) or (9).
3. Wait 5 seconds. Remaining operating time
is stored.
Fault Diagnosis by Coded Light Signals
On heaters equipped with a fault diagnosis
system using coded light signals, the equipment-
on indicator/operation indicator flashes. Please
consult your Webasto dealer.
TROUBLESHOOTING AND MAINTENANCE
The Espar preheater has a diagnostic code
system, so the driver is informed when
something goes wrong. Codes are listed in
“Technical Information” chapter under “Espar
Preheater Diagnostic Codes”.
The diagnostic code system in Webasto timers
is optional. Refer to the Maintenance Manual
and to Webasto or Espar manuals for more
information.
Note: If there are no heater faults, the heater
will go through a normal start cycle and regulate
based on thermostat setting.
Note: Switch on the preheating system briefly
about once a month, even during the warm
season.
Caution: When welding on the vehicle,
disconnect the preheater module connector in
order to protect this system from voltage surges.
Caution: To avoid running down the batteries,
do not turn on the preheating system for more
than one hour before starting the engine.
Warning: The preheating system uses the
same fuel as the engine. Do not operate in a
building or while refueling. Operate only in a
well-ventilated area.
WHEELCHAIR LIFT
Read and understand the RICON or Stewart and
Stevenson Service/Owner’s Manual before
attempting to use the wheelchair lift. The
instructions below are a quick reference and
serve to complement the information provided by
the lift manufacturer.
Warning: To operate the optional wheelchair
lift, the coach must be parked on a flat and level
surface, with the parking brake applied.
Activate the lift mechanism circuit by pressing
down on the wheelchair rocker switch on the
dashboard.
69
To Next Page
Loading...
