Printronix P7010 - Page 283

Fault Messages
283
SPX FOUND, ERROR:
KEY NOT DETECTED
No The controller board does
not have a security key.
Contact your authorized service
representative.
1
SPX NOT NEEDED
OPTIONS ENABLED
No The user has attempted
to use the SPX to turn on
printer options that are
already enabled.
Contact your authorized service
representative.
1
STACK OVERFLOW* No Firmware error on
controller board.
Contact your authorized service
representative.
1
STACK UNDERFLOW* No Firmware error on the
controller board.
Contact your authorized service
representative.
1
STACKER FAULT Yes Stacker is not functioning
correctly.
Check for obstructions in the
stacker area. If fault persists,
contact your authorized service
representative.
1
STACKER FULL Yes Status message: the
power paper stacker is
full of paper.
Unload the stacker. If fault persists,
contact your authorized service
representative.
1
STACKER JAM Yes This message is
triggered if there is paper
inside the throat of the
stacker elevator, but the
elevator is not moving.
1. Open the cabinet rear door and
check for obstructions preventing
elevator movement. Remove any
obstructions.
2. Run the print job again. If the
message appears again, contact
your authorized service
representative.
1
TCB CORRUPTED* No Task Control Block
Corrupted. Firmware
error on controller board.
Contact your authorized service
representative.
1
TCP PORT BUSY Yes Error message reported
by the Printer Manager
when ethernet interface
option is installed. The
network address given in
the printer properties was
reached, but the printer
port is busy.
Refer to the Printronix P7000
Maintenance Manual
.
UNDEF INTERRUPT* No Undefined Interrupt.
Firmware error on
controller board.
Contact your authorized service
representative.
1
UNDFNED OPCODE* No Undefined Opcode.
Firmware error on
controller board.
Contact your authorized service
representative.
1
Table 15. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution