Priva Compass - Switching the Compass System on and off

Switching the Compass system on and off
Switch on
1. Switch on the Compass system by switching on the circuit breaker.
2. Switch on the controller and the Mix I/O module (if present) with the on/off button. See Switching
system power on and off (page 32).
This automatically switches on the other Priva Blue ID modules that are connected to the
controller and Mix I/O module.
Switch off
1. Perform a shutdown of the controller. See Performing a shutdown (page 40).
2. Switch off the controller and the Mix I/O module (if present) with the on/off button. See Switching
system power on and off (page 32).
3. Switch the Compass system off by switching off the circuit breaker.
This switches off the power supplies in the Compass cabinet, which automatically switches off
the sensors that are powered by the system.
Testing
Perform the following tests after switching on the system or in the event of malfunctions.
1. Check the LEDs on the controller, the Mix I/O module and expansion modules.
The blue line-up LED (all modules) must be on continuously.
The green status LED for controller (C) (on controller only) must be on continuously.
The green status LED for I/O (I/O) (all modules) must be on continuously.
2. Check whether the power indicator LEDS on the power supplies are on.
3. Check the LEDs on the Priva Gateway.
The green LED for the supply voltage must be on continuously.
The green LED for SSD activity will flicker when information is being written to the hard disk.
4. Test the operation of the sensors.
See the chapters in this manual for the relevant sensor or the manuals of connected systems.
See also Troubleshooting the Compass system (page 31).
Installing Priva Compass - 00.01422
Priva