What to do if my Priva Compass system does not switch on?
If your Priva Farm Equipment system isn't switching on, here are a few things you can check: * Ensure the cabinet is receiving power. * Verify the mains voltage is set correctly on the 24 VAC transformer. * Make sure the circuit breaker is on. * Confirm that the controller and Mix I/O module are powered on. * Inspect the fuse.
Why are the sensors not receiving power in my Priva Compass?
If the sensors in your Priva Farm Equipment aren't receiving power, please check the following: * Verify the 24 VDC power supplies and ensure the indication LEDs are lit. * Inspect the 24 VAC transformer. * Check any external power supplies you may be using. * Check the fuse and circuit breaker. * Ensure all connections are secure.
How to fix Priva Blue ID modules that won't switch on in Farm Equipment?
If your Priva Blue ID modules aren't switching on, try these steps: * Check that the circuit breaker is on. * Ensure the 24 VDC power supplies are working and the indication LEDs are lit. * Verify that the controller and Mix I/O module are powered on. * Confirm that Priva Blue ID expansion modules are connected with the I/O bus cable to the controller or Mix I/O module. Remember to switch off the modules before inserting an I/O bus cable.
General| Brand | Priva |
|---|---|
| Model | Compass |
| Category | Farm Equipment |
| Language | English |
Provides essential safety rules for working with the product and maintaining it.
Details critical safety instructions for electrical connections and component handling.
Outlines the initial steps for installing the Compass system and its software.
Step-by-step guide for installing and connecting various field equipment.
Details requirements for commissioning, including latest software versions.
Explains the setup of the industrial Priva network and its separation from the office network.
Guides on setting up the Gateway via Wi-Fi or wired connection and software updates.
Lists common problems and their possible causes and solutions.
Procedure for resetting the VDC power supply if 24 VDC is not outputting.
General rules for connecting field equipment and using 24 VDC power supply.
Lists connections for C4 controller and MX34 module (power, I/O, RS485, etc.).
Overview of the WSC11's capabilities and measurements for horticulture.
Guidelines for selecting the best location for representative weather measurements.
Describes the Meteorological station's design for optimal weather sensor positioning.
Explains the WI2's role in connecting sensors and its splashproof housing.
Guides on setting jumpers for Linear light and Radiation sensors.
Explains how the light sensor measures sunlight intensity.
Explains how the RD2WI sensor detects rain and its limitations.
Explains how the sensor determines wind direction and its output signal.
Explains how the sensor generates pulses based on wind speed.
Explains the sensor's use of an NTC resistor for temperature measurement.
Explains how to connect the flow sensor to record volume flow.
Covers checking operation, setting load cell data, and calibration.
Procedure for entering load cell sensitivity and zero point data.
Common problems with the weighing indicator and their solutions.
To Next Page