Priva Compass - Setting the Weather Interface WI2 Jumpers

Setting the Weather interface WI2 jumpers
The Weather interface has jumpers for setting the type of sensor (Linear light sensor or Radiation
sensor CM3P) and the Radiation sensor factor.
For the Linear light sensor:
1. Remove jumper J3.
2. Connect jumper S on J2:
3. Remove jumper G from J2.
4. Connect or remove the other jumpers in accordance with the table below and the sensor's
Radiation sensor factor. This value is stated on the supplied calibration certificate.
For the Radiation sensor CM3P:
1. Remove jumper J3.
2. Remove jumper S of J2:
3. Remove jumper G from J2.
4. Connect or remove the other jumpers in accordance with the table below and the specific
sensitivity of the sensor. This value is stated on the supplied calibration certificate.
Jumper FJumper EJumper DJumper CJumper BJumper ASensor
radiation
factor max
Sensor
radiation
factor min
XXXXXX343.64
-XXXXX343.64338.44
X-XXXX338.44333.41
--XXXX333.41328.49
XX-XXX328.49323.72
-X-XXX323.72319.11
X--XXX319.11314.63
---XXX314.63310.25
XXX-XX310.25305.99
-XX-XX305.99301.86
X-X-XX301.86297.85
--X-XX297.85293.92
XX--XX293.92290.09
-X--XX290.09286.39
X---XX286.39282.78
----XX282.78279.12
XXXX-X279.12275.55
-XXX-X275.55272.21
X-XX-X272.21268.94
--XX-X268.94265.73
XX-X-X265.73262.60
-X-X-X262.60259.56
X--X-X259.56256.59
---X-X256.59253.66
XXX--X253.66250.81
-XX--X250.81248.03
61Installing Priva Compass - 00.014
Weather interface WI2