Promise Technology SMARTSTOR NS4300N - Making Management Settings; Configuring a NAS System

Chapter 5: SmartNAVI
91
Making Management Settings
This category includes the following topics:
• Configuring a NAS System (page 91)
• Changing Network Settings (page 93)
• Locating the SmartStor (page 94)
• Choosing a Default NAS System (page 94)
• Enabling or Disabling Event Notification (page 94)
• Viewing the System Event Log (page 95)
• Adding Application Plug-ins (page 95)
• Viewing a List of Plug-ins (page 96)
• Viewing Plug-in Version Numbers (page 96)
• Enabling and Disabling Plug-ins (page 97)
• Removing Plug-ins (page 97)
• Rebooting the SmartStor (page 98)
• Shutting Down the SmartStor (page 98)
• Restarting the SmartStor (page 99)
Configuring a NAS System
The Setup Wizard has two modes:
• One Click Setup – Loads a collection of default settings. Recommended for
most users.
• Advanced Setup – Enables you to make your own settings. Recommended
for advanced users.
One Click Setup
To configure your NAS system using One Click Setup:
1. Go to the Main Window.
2. Click the Setup Wizard icon.
3. Click the One Click Setup button.
4. Click the OK button.
Caution
Do NOT run the Setup Wizard on a NAS system that is already
configured! That action will delete your data and network drives!