Chapter 6: PASM
141
Making Management Settings
This category includes the following topics:
• Viewing the Event Log (page 141)
• Setting up SMTP Authentication (page 141)
• Sending a Test Message (page 142)
• Viewing the Email Alert List (page 142)
• Adding an Email Alert Recipient (page 143)
• Deleting an Email Alert Recipient (page 143)
• Upgrading the System Firmware (page 143)
• Adding Application Plug-ins (page 143)
• Removing Plug-ins (page 144)
• Enabling and Disabling the Buzzer (page 144)
• Viewing UPS Status (page 145)
• Setting up a UPS (page 145)
• Setting up System Standby (page 146)
Viewing the Event Log
The event log keeps a log of the 20 most recent events on the SmartStor. You
can use this information to review your actions and to diagnose problems.
To view the Event Log:
1. In the Tree, click the + beside the Management icon.
2. Click the Event Log icon.
A list of the 20 most recent events displays on the Event Log tab.
Events are ranked in severity as Information, Warning, and Error.
Setting up SMTP Authentication
In order to set up email alerts over a network, you must enable the SMTP
service, specify a SMTP server, and in most cases, supply authentication
information. See your Network Administrator for help with these settings.
To set up SMTP authentication:
1. In the Tree, click the + beside the Management icon.
2. Click the Mail Alert icon.
3. Click the Setup tab.
4. Next to Service, click the Enable option button.
To Next Page
Loading...
Need help?
General
