Chapter 1: Introduction to SmartStor
3
Specifications
• Disk drive support:
• Four 1.5 Gb/s or 3 Gb/s SATA 3.5-inch disk drives
• Conforms to Serial ATA 1.0 specification and Serial ATA II: Extensions
to Serial ATA 1.0 specification (SATA II, phase I specification)
• SATA specification of 3 Gb/s transfers with CRC error-checking
• Hot-swapping of disk drives
• Tagged command queuing
• Native command queuing
• Drive roaming among channels
• S.M.A.R.T. status polled every 15 minutes
• Online capacity expansion
• RAID Level Migration
• Hot spare drives
• RAID Volume rebuilding
• Gigabyte rounding
• Background rebuilding
• RAID level support: RAID 0, 1, 5, and 10
• Large file system support up to 6 TB
• Unicode file name support
• SATA RAID Controller: Promise PDC40719
• Server on a Chip: Freescale MPC8343, 400MHz
• Networking: 10/100/1000 Mb/s Ethernet Port on motherboard
• USB ports: USB 2.0, up to 480 Mb/s, two Type-A connectors
• File protocols: SMB, CIFS, FTP, AFP, NFS
• Flash Memory: 16 MB, 16-bit
• Memory: 128 MB DDR SDRAM
• Power Supply: 200-watt ATX with PFC
• Network Time Protocol (NTP) client
• Error logging
• Phone home capability (email notification) to contact IT staff
• Hardware monitoring of:
•Fan
• Temperature
•Power
• Disk status
• One-Touch button
• Enclosure status
To Next Page
Loading...
Need help?
General
