How to Set [Redate] Mode printing
If you have a mail piece that has been stamped with a date that is not the actual date
you are mailing the piece, you must “Redate” the mail piece before mailing. Redating
is done by applying a “0” value date correction indicia (stamp) to the envelope / item.
• Only one date correction indicia (stamp) is permitted.
• On letter size mail, place the date correction indicia (stamp)
on the non-address side of the envelope in the upper right
corner.
• If the date stamp is printed on a label, it may be placed
on the address side of the envelope in the lower left corner.
Set the Stamp Type:
3
Processing Mail
55
| Page 55 | Apr-28-2023 03:14 |
To Next Page
Loading...
