Qualstar Q48 - Page 90

Q24/Q48 Tape Library Installation and Operations Manual
Error
Code
Description
User Action
Critical Component Status
D4
UART Error.
Frame overrun or Parity
Error on serial
Interface.
Retry operation; after
several occurrences
contact technical support
Check library and media changer
controller
D5
Display Error
Communication to
display failed
Retry operation; after
several occurrences
contact technical support
Check library controller and OCP
D6
Memory Error, Stack
and heap overflow.
Retry operation; after
several occurrences
contact technical support
Library controller probably defective.
D7
Fatal system error
Retry operation; after
several occurrences
contact technical support
Library controller probably defective.
Probably a hardware problem, check
library controller
D8
Data base error
Retry operation; after
several occurrences
contact technical support
Library controller probably defective.
Probably a hardware problem, check
library controller
D9
No SCSI IC detected
Retry operation; after
several occurrences
contact technical support
SCSI controller probably defective.
Check SCSI controller and library
controller
DA
In Library Verify Test
the barcode reader has
read different barcode
data for the same
cartridge label
Check barcode label on
scratch cartridge and run
Library Verify Test again.
If the error recurs,
contact technical support
DB
Warning event!
See section below
DC
I²C Bus Failure
Retry operation; after
several occurrences
contact technical support
Failure in I²C bus communication.
Check library controller and connections
to OCP and backplane.
Check OCP.
Check backplane.
Check drive sleds.
DD
Warning event!
See section below
DE
Warning event!
See section below
DF
Warning event!
See section below
E0
Incompatible magazine
detected
Check type of lowest left
magazine
Magazine type not supported.
© Copyright QUALSTAR 2015 81