Quanta Computer QuantaMesh - VM Tracer Commands; Show Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Data Center Bridging Commands
1002
9.5 VM Tracer Commands
9.5.1 Show Commands
9.5.1.1 show vmtracer interface
This command displays VM Tracer interface mode on all interfaces or the VM interface (Vnics) that are
on the specific switch interface where the VM Tracer interface mode is enabled.
Syntax
show vmtracer interface [<slot/port>]
<slot/port> - show the VM interface (Vnics) that are on the <slot/port> where the VMTracer interface
mode is enabled.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Port: the physical interface number of the device.
VM Tracer: the VM Tracer interface mode state. The value should be Enable or Disable.
VM Name: the name of attached VM.
VM Adapter: the adapter name of the VM interface.
VLAN: the VLAN value of the VM interface.