Quanta Computer QuantaMesh - Ip Helper Commands; Show Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
728
6.5 IP Helper Commands
6.5.1 Show Commands
6.5.1.1 show ip helper-address
Use this command to display the IP helper address configuration.
Syntax
show ip helper-address
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Interface: The relay configuration is applied to packets that arrive on this interface. This field is set to
‘any’ for global IP helper entries.
UDP Port: The relay configuration is applied to packets whose destination UDP port is this port.
Discard: Indicate discard the UDP packets or not.
Hit Count: The number of times the IP helper entry has been used to relay or discard a packet.
Server Address: The IPv4 address of the server to which packets are relayed.