Quanta Computer QuantaMesh - Show Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
611
5.24.1 Show Commands
5.24.1.1 show auto-voip
Use this command to display the VoIP Profile settings on the interface or interfaces of the switch.
Syntax
show auto-voip {oui-based [interface [{< slot/port > | port-channel <portchannel-id>}]] | protocol-based
interface [{< slot/port > | port-channel <portchannel-id>}] | oui-table}
< slot/port > - The interface number.
<portchannel-id> - The port-channel interface number. The range of port-channel ID is 1 to 64.
oui-based - Show OUI based auto VoIP
oui-table - Show Auto VoIP OUI Table
protocol-based - Show call control protocol based auto VoIP
Default Setting
None
Command Mode
Privileged EXEC
Display Message
AutoVoIP Mode: The Auto VoIP mode on the interface.
Traffic Class: The CoS Queue or Traffic Class to which all VoIP traffic is mapped to. This is not
configurable and defaults to the highest CoS queue available in the system for data traffic.