Quanta Computer QuantaMesh - Configuration Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
736
6.6.2 Configuration Commands
6.6.2.1 enable rip
This command resets the default administrative mode of RIP in the router (active).
Syntax
enable
no enable
no - This command sets the administrative mode of RIP in the router to inactive.
Default Setting
Enabled
Command Mode
Router RIP Config
6.6.2.2 ip rip
This command enables RIP on a router interface.
Syntax
ip rip
no ip rip
no - This command disables RIP on a router interface.
Default Setting
Disabled
Command Mode
Interface Config