Quanta Computer QuantaMesh - Configuration Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
612
5.24.2 Configuration Commands
5.24.2.1 auto-voip
Use this command to enable VoIP Profile on the interfaces of the switch.
Syntax
auto-voip {{oui <oui-prefix> oui-desc <string>} | {oui-based [priority <priority-value>]} | {protocol-based
[remark <0-7> | traffic-class <0-7>]} | {vlan <vlan-id>}}
no auto-voip {{oui <oui-prefix>} | {oui-based [priority]} | {[protocol-based {remark| traffic-class}]} | vlan}
no - Use this command to disable VoIP Profile on the interfaces of the switch.
Default Setting
Disable
Command Mode
Global Config.
5.24.2.2 auto-voip
Use this command to enable VoIP Profile on an interface or range of interfaces.
Syntax
auto-voip {oui-based | protocol-based}
no auto-voip {oui-based | protocol-based}
no - Use this command to disable VoIP Profile on the interface.
Default Setting
Disable
Command Mode
Interface Config.