Quanta Computer QuantaMesh - Configuration Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
725
6.4.2 Configuration Commands
6.4.2.1 bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Syntax
bootpdhcprelay cidoptmode
no bootpdhcprelay cidoptmode
no - This command is used to disable the circuit ID option mode for BootP/DHCP Relay on the
system.
Default Setting
Disabled
Command Mode
Global Config
6.4.2.2 bootpdhcprelay enable
This command enables the forwarding of relay requests for BootP/DHCP Relay on the system.
Syntax
ip helper enable
no ip helper enable
no - Disable the forwarding of relay requests for BootP/DHCP Relay on the system.
Default Setting
Disabled
Command Mode
Global Config
6.4.2.3 bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the
system.