Quanta Computer QuantaMesh - Fip-Snooping Vlan

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Data Center Bridging Commands
990
9.1.7 fip-snooping vlan
This command enables FIP snooping on a VLAN. VLAN must be configured before it can be used. Once
VLAN is enabled, the FIP packets will be snooped only on the configured VLANs. FIP snooping is
disabled on VLANs by default.
Syntax
fip-snooping vlan <1-4093>
no fip-snooping vlan <1-4093>
<1 - 4093> - VLAN ID.
no - This command disable snooping on a specific VLAN.
Default Setting
Disabled
Command Mode
DCB (Data Center Bridging) Config