Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands
7.2 Internet Group Management Protocol (IGMP) Commands
This section provides a detailed explanation of the IGMP commands. The commands are divided into
the following different groups:
Show commands are used to display device settings, statistics and other information.
Configuration commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
7.2.1 Show Commands
7.2.1.1 show ip igmp
This command displays the system-wide IGMP information.
Syntax
show ip igmp
Default Setting
None
Command Mode
Privileged Exec
User EXEC
Display Message
IGMP Admin Mode: This field displays the administrative status of IGMP. This is a configured
value.
IGMP Router-Alert check: This field displays the administrative status of Router-Alert validation for
IGMP packets.
Interface: Valid slot and port number separated by forward slashes.
Interface Mode: This field indicates whether IGMP is enabled or disabled on the interface. This is a
configured value.
Operational-Status: This field indicates the current state of IGMP on this interface. Possible values
are Operational or Non-Operational.
To Next Page
Loading...