5.24 Auto-Voice over IP Commands
This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands. The
Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and provides them with a better
class-of-service than ordinary traffic. When you enable the Auto-VoIP feature on an interface, the
interface scans incoming traffic for the following call-control protocols:
Session Initiation Protocol (SIP)
H.323
Skinny Client Control Protocol (SCCP)
When a call-control protocol is detected, the switch assigns the traffic in that session to the highest CoS
queue, which is generally used for time-sensitive traffic.
To Next Page
Loading...