Some of the information below displays only if you enable OSPF and configure certain
features.
Router ID : A 32-bit integer in dotted decimal format identifying the router, about which information is
displayed. This is a configured value.
OSPF Admin Mode : Shows whether the administrative mode of OSPF in the router is enabled or
disabled. This is a configured value.
RFC 1583 Compatibility : Indicates whether 1583 compatibility is enabled or disabled. This is a
configured value.
External LSDB Limit : The maximum number of non-default AS-external-LSA (link state
advertisement) entries that can be stored in the link-state database.
Exit Overflow Interval : The number of seconds that, after entering overflow state, a router will
attempt to leave overflow state.
Spf Delay Time : The number of seconds between two subsequent changes of LSAs, during which
time the routing table calculation is delayed.
Spf Hold Time: The number of seconds between two consecutive spf calculations.
Flood Pacing Interval: The average time, in milliseconds, between LS Update packet transmissions
on an interface. This is the value configured with the timers pacing flood command.
LSA Refresh Group Pacing Time: The size of the LSA refresh group window, in seconds. This is
the value configured with the timers pacing lsa-group command.Opaque Capability: Shows
whether the router is capable of sending Opaque LSAs. This is a configured value.
!
To Next Page
Loading...