Quanta Computer QuantaMesh - Configuration Commands

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
798
6.11.2 Configuration Commands
6.11.2.1 router bgp
Use this command to the Border Gateway Protocol (BGP) routing mode .
Syntax
router bgp <autonomous-system-number>
autonomous-system-number - Number of an autonomous system that identifies the router to other
BGP routers and tags the routing information that is passed along. Number in the range from 1 to
65535.
Default Setting
None
Command Mode
Global Config
6.11.2.2 enable
Use enable command resets the default administrative mode of BGP in the router (active). no enable
command sets the administrative mode of BGP in the router to inactive
Syntax
enable
no enable
Default Setting
Enabled
Command Mode
Router BGP Config Mode