Quanta Computer QuantaMesh - Page 799

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
799
6.11.2.3 aggregate-address
Use aggregate-address command to create an aggregate entry in a Border Gateway Protocol (BGP)
database. Use no aggregate-address command to disable an aggregate entry in a Border Gateway
Protocol (BGP) database.
Syntax
aggregate-address <address> <mask> [as-set] [summary-only]
no aggregate-address <address> <mask> [as-set] [summary-only]
address - Aggregate address.
mask - Aggregate mask.
as-set - Generates autonomous system set path informatio.
summary-only - Filters all more-specific routes from update.
Default Setting
The atomic aggregate attribute is set automatically when an aggregate route is created with this
command unless the as-set keyword is specified.
Command Mode
Router BGP Config Mode
6.11.2.4 bgp aggregate-different-meds
Use bgp aggregate-different-meds command to allow aggregation of routes with different MED values.
Use no bgp aggregate-different-meds command to disable this function.
Syntax
bgp aggregate-different-meds
no bgp aggregate-different-meds
Default Setting
Disabled
Command Mode
Router BGP Config Mode