9.5.2.2 allow-vlan
The command specifies the VLANs that may be added when a VM is added or moved from the
hypervisor connected to the session specified by the vmtracer mode. By default, all VLANs are allowed.
Syntax
allow-vlan {<vlan-list> | {add | remove <vlan-list>} | none | all}
<vlan-list> - Enter VLAN IDs in range <1-4093>. Use ‘-‘ to specify a range, or ‘,’ to separate VLAN
IDs in a list. Spaces and Zeros are not permitted.
<add> - Add VLAN IDs to current allow-vlan list.
<remove> - Remove VLAN IDs from current allow-vlan list.
<none> - Make allow-vlan list to be empty.
<all> - Add all VLAN IDs to current allow-vlan list.
Default Setting
all
Command Mode
VM Tracer Config
To Next Page
Loading...