Quanta Computer QuantaMesh - Page 126

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
126
5.2.6.18 show ip igmp snooping mrouter interface
The user can go to the CLI Privilege Exec to display information about statically configured multicast
router-attached interfaces, use the show ip igmp snooping mrouter interface Privilege command.
Syntax
show ip igmp snooping mrouter interface {<slot/port> | port-channel <portchannel-id>}
<slot/port> - Interface number.
<portchannel-id> - Port-channel interface number. The range of port-channel ID is 1 to 64.
Default Setting
None
Command Mode
Privilege Exec
Display Message
Interface: Shows the interface on which multicast router information is being displayed.
Multicast Router Attached: Indicates whether multicast router is statically enabled on the interface.