5.2.8.7 show ipv6 mld snooping ssm groups
The user can go to the CLI Privilege Exec to display the MLD Snooping ssm groups in the Source
Specific Multicast Forwarding Database (MFDB) table, use the show ipv6 mld snooping ssm groups
Privilege command.
Syntax
show ipv6 mld snooping ssm groups
Default Setting
None
Command Mode
Privilege Exec
Display Message
VLAN ID: VLAN on which the MLDv2 report is received.
Group: The IPv6 multicast group address.
Interface: The interface on which the MLDv2 report is received.
Reporter: The IPv6 address of the host that sent the MLDv2 report.
Source Filter Mode: The source filter mode (Include/Exclude) for the specified group.
Source Address List: List of source IP addresses for which source filtering is requested.
To Next Page
Loading...