Quanta Computer QuantaMesh - Page 171

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
171
This command set <actor | partner> port priority value of Link Aggregation Control Protocol (LACP) on a
port.
Syntax
lacp <actor|partner> port priority <priority-value>
no lacp <actor|partner> port priority
<priority-value> – range 0-65535.
no - This command restores <actor | partner> port priority value of Link Aggregation Control Protocol
(LACP) on a port.
Default Setting
128
Command Mode
Interface Config
This command set <actor | partner> system priority value of Link Aggregation Control Protocol (LACP).
Syntax
lacp <actor|partner> system priority <priority-value>
no lacp <actor|partner> system priority
<priority-value> – range 0-65535.
no - This command restores <actor | partner> system priority value of Link Aggregation Control
Protocol (LACP).
Default Setting
32768
Command Mode
Interface Config