Quanta Computer QuantaMesh - Page 181

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
181
5.2.11.5 storm control action
This command configure what actions will be performed while the storm control is detected. The actions
include shutdown the interfae and send a SNMP trap if the storm occurs.
Syntax
storm-control action {shutdown | trap}
no storm-control {shutdown | trap}
shutdown – To shutdown the interface if the storm occurs.
trap – To send SNMP trap if the storm occurs.
no - This command disables unicast storm recovery mode on all interfaces.
Default Setting
None
Command Mode
Interface Config