Quanta Computer QuantaMesh - Page 242

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
242
5.3.6.6 snmptrap source-interface
Use this command in Global configuration mode to configure the global source-interface (Source IP
address) for all SNMP communications between the SNMP client and the server. This command takes
effect for both SNMP trap and inform client.
.
Syntax
snmptrap source-interface {<slot/port> | loopback <loopback-id> | tunnel <tunnel-id> | vlan <vlan-id>}
no snmptrap source-interface
<slot/port> - Specifies the interface to use as the source interface.
<loopback-id> - Specifies the loopback interface to use as the source interface. The range of the
loopback ID is 0 to 7.
<tunnel-id> - Specifies the tunnel interface to use as the source interface. The range of the tunnel
ID is 0 to 7.
<vlan-id> - Specifies the VLAN interface to use as the source interface. The range of VLAN ID is 1
to 4093.
no - This command removes the global source-interface for all SNMP communication between the
SNMP client and the server.
Default Setting
None
Command Mode
Global Config