Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
5.3.14.7 serviceport ipv6 gateway
Use this command to configure IPv6 gateway (i.e. Default routers) information for the service port.
Syntax
serviceport ipv6 gateway <gateway-address>
no serviceport ipv6 gateway
<gateway-address>: Gateway address in IPv6 global or link-local address format.
no - This command remove IPv6 gateways on the service port interface.
Only a single IPv6 gateway
address can be configured for the service port. There may be a
combination of IPv6 prefixes and gateways that are explicitly configured and those that are
set through auto-address configuration with a connected IPv6 router on their service port
interface.
Default Setting
None
Command Mode
Global Config
i
To Next Page
Loading...