Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
Trap: The relevant information of this trap.
Trap log information is not retained across a switch reset.
5.5.1.4 show logging hosts
This command displays all configured logging hosts.
Syntax
show logging hosts
Default Setting
None
Command Mode
Privileged Exec
Display Message
Index: used for deleting.
IP Address:IP Address of the configured server.
Severity: The minimum severity to log to the specified address.
Port Server Port Number:This is the port on the local host from which syslog messages are sent.
Status: The state of logging to configured syslog hosts. If the status is disable, no logging occurs.
i
To Next Page
Loading...