Quanta Computer QuantaMesh - Page 305

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
305
5.5.2.2 logging console
This command enables logging to the console.
Syntax
logging console [<severitylevel> | <0-7>]
no logging console
[<severitylevel> | <0-7>] - The value is specified as either an integer from 0 to 7 or symbolically
through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), informational (6), debug (7).
no - This command disables logging to the console.
Default Setting
None
Command Mode
Global Config
5.5.2.3 logging monitor
This command enables logging to the terminal monitor.
Syntax
logging monitor [<severitylevel> | <0-7>]
no logging monitor
[<severitylevel> | <0-7>] - The value is specified as either an integer from 0 to 7 or symbolically
through one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), informational (6), debug (7).
no - This command disables logging to the terminal monitor.
Default Setting
None
Command Mode
Globla Config