Quanta Computer QuantaMesh - Page 337

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
337
5.9.1.6 show dot1x
This command is used to show the status of the dot1x Administrative mode.
Syntax
show dot1x
Default Setting
None
Command Mode
Privileged Exec
Display Message
Administrative mode: Indicates whether authentication control on the switch is enabled or disabled.
VLAN Assignment Mode: Indicates whether assignment of an authorized port to a RADIUS
assigned VLAN is allowed (enabled) or not (disabled).
Dynamic VLAN Creation Mode: Indicates whether the switch can dynamically create a
RADIUS-assigned VLAN if it does not currently exist on the switch.
Monitor Mode: Indicates whether the Dot1x Monitor mode on the switch is enabled or disabled.