Quanta Computer QuantaMesh - Page 345

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
345
5.9.1.13 show radius
This command is used to display the various RADIUS configuration items for the switch.
Syntax
show radius
Default Setting
None
Command Mode
Privileged Exec
Display Message
Number of Configured Authentication Servers: The number of RADIUS Authentication servers
that have been configured.
Number of Configured Accounting Servers: The number of RADIUS Accounting servers that
have been configured.
Number of Named Authentication Server Groups: The number of configured named RADIUS
Authentication server groups.
Number of Named Accounting Server Groups: The number of configured named RADIUS
Accounting server groups.
Number of Retransmits: The configured value of the maximum number of times a request packet is
retransmitted.
Timeout Duration: The configured timeout value, in seconds, for request re-transmissions.
Dead Time: The configured timeout value, in mins, for the time duration after a RADIUS sever is
found non-responsive or dead.
RADIUS Accounting Mode: A global parameter to indicate whether the accounting mode for all the
servers is enabled or not.
RADIUS Attribute 4 Mode: A global parameter to indicate whether the NAS-IP-Address attribute
has been enabled to use in RADIUS requests.
RADIUS Attribute 4 Value: A global parameter that specifies the IP address to be used in the
NAS-IP-Address attribute to be used in RADIUS requests.
RADIUS Attribute 95 Mode: A global parameter to indicate whether the NAS-IPv6-Address attribute
has been enabled to use in RADIUS requests.
RADIUS Attribute 95 Value: A global parameter that specifies the IPv6 address to be used in the
NAS-IP-Address attribute to be used in RADIUS requests.