show radius servers [{<ipaddr | ipv6addr | hostname> | name <servername>}]
Default Setting
None
Command Mode
Privileged Exec
Display Message
RADIUS Server Name: The Name of the authenticating server.
RADIUS Server IP Address: The IP address or host name of the authenticating server.
Current Server IP Address: The ‘*’ symbol preceeding the server host address specifies that the
server is currently active.
Number of Retransmits: The configured value of the maximum number of times a request packet is
retransmitted.
Timeout Duration: The configured timeout value, in seconds, for request re-transmissions.
Dead Time: The configured timeout value, in mins, for the time duration after a RADIUS sever is
found non-responsive or dead.RADIUS Accounting Mode: A global parameter to indicate whether
the accounting mode for all the servers is enabled or not.
RADIUS Attribute 4 Mode: A global parameter to indicate whether the NAS-IP-Address attribute
has been enabled to use in RADIUS requests.
RADIUS Attribute 4 Value: A global parameter that specifies the IP address to be used in the
NAS-IP-Address attribute to be used in RADIUS requests.
RADIUS Attribute 95 Mode: A global parameter to indicate whether the NAS-IPv6-Address attribute
has been enabled to use in RADIUS requests.
RADIUS Attribute 95 Value: A global parameter that specifies the IPv6 address to be used in the
NAS-IP-Address attribute to be used in RADIUS requests.
Port: The port in use by this server
Type: Primary or secondary
Secret Configured: Yes / No
Message Authenticator: The message authenticator attribute configured for the radius server.
To Next Page
Loading...