5.9.1.21 show port-security interface
This command shows the port-security settings for a particular interface or all interfaces.
Syntax
show port-security { <slot/port> | all | port-channel < portchannel-id >}
<slot/port> - is the interface number.
<portchannel-id> - is the desired port-channel ID. The port-channel ID is range from 1 to 64.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Intf Interface Number.
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap Mode Whether violation traps are enabled.
Sticky Mode Whether sticky mode is enabled.
Violation Shutdown Whether violation shutdowns are enabled.
To Next Page
Loading...