Quanta Computer QuantaMesh - Page 365

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
365
5.9.3.7 dot1x max-user
This command configures the maximum users to a specified port, The system’s default maximum users
of an interface has no limitation. If ‘no dot1x max-users’ command is executed, the system will reset the
maximum users to infinity. If the maximum users is specified or modified, the system should use the new
one.
Syntax
dot1x max-user <count>
no dot1x max-user
<count> - maximum users (Range: 1 – 48).
no - This command sets the system will reset the maximum users to infinity
Default Setting
48
Command Mode
Interface Config
5.9.3.8 dot1x pae
This command set the PAE capability mode on the specified port.
Syntax
dot1x pae <authenticator| supplicant>
Default Setting
authenticator
Command Mode
Interface Config