dot1x timeout {guest-vlan-period | quiet-period | reauth-period | server-timeout | supp-timeout |
tx-period} <seconds>
no dot1x timeout { guest-vlan-period | quiet-period | reauth-period | server-timeout | supp-timeout |
tx-period}
<seconds> - Value in the range
guest-vlan-period: 1-300
reauth-period: 1-65535
quiet-period: 0-65535
tx-period: 1-65535
supp-timeout: 1-65535
server-timeout: 1-65535
no - This command sets the value, in seconds, of the timer used by the authenticator state machine
on this port to the default values. Depending on the token used, the corresponding default values are
set.
Default Setting
guest-vlan-period: 90 seconds
reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds
Command Mode
Interface Config
To Next Page
Loading...