Quanta Computer QuantaMesh - Page 381

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
381
This command is used to configure the TACACS+ authentication host priority.
Syntax
priority [<priority>]
<priority> - The valid priority number. Range (0 – 65535)>
Default Setting
0
Command Mode
TACACS Host Config
This command is used to configure the TACACS+ connection timeout value.
Syntax
timeout [<timeout>]
<timeout> - The connection timeout value. Max timeout (Range: 1 to 30).
Default Setting
5
Command Mode
TACACS Host Config