Quanta Computer QuantaMesh - Page 451

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
451
5.13.2.3 vtp mode
This command uses to set VTP device mode. There are theree modes you can configure, Client,
Server, and Transparent.
Syntax
vtp mode { client | server | transparent }
no vtp mode
<client> - This command set client mode for VTP.
<server> - This command set server mode for VTP.
<transparent> - This command set transparent mode for VTP.
no - This command resets the VTP mode to default value.
Default Setting
Server
Command Mode
Global Config
5.13.2.4 vtp version
Use the no vtp version to reset the VTP version number to default value..
Syntax
vtp version <1-2>
no vtp version
no - This command resets the VTP version to default value.
Default Setting
1
Command Mode
Global Config