5.20.3.13 police-single-rate
This command is the single-rate form of the police command and is used to establish the traffic policing
style for the specified class. For each outcome, the only possible actions are drop, set-cos-as-sec-cos,
set-cos-transmit, set-sec-cos-transmit, set-dscp-transmit, set-prec-transmit, or transmit. In this
single-rate form of the police command, the conform action defaults to send, the exceed action defaults
to drop, and the violate action defaults to drop. These actions can be set with this command once the
style has been configured.
Syntax
police-single-rate {1-4294967295 1-128 1-128 conform-action {drop | set-cos-as-sec-cos |
set-cos-transmit 0-7 | set-prec-transmit 0-7 | set-dscp-transmit 0-63 | transmit} exceed-action {drop |
set-cos-as-sec-cos | set-cos-transmit 0-7 | set-prec-transmit 0-7 | set-dscp-transmit 0-63 | transmit}
[violate-action {drop | set-cos-as-sec-cos | set-cos-transmit 0-7 | set-prec-transmit 0-7 |
set-dscp-transmit 0-63 | transmit}]}
<conform-action & violate-action & exceed-action > - The conforming data rate is specified in
kilobits-per-second (Kbps) and is an integer from 1 to 4294967295. The conforming burst size is
specified in kilobytes (KB) and is an integer from 1 to 128. For each outcome, the only possible
actions are drop, set-dscp-transmit, set-prec-transmit, or set-cos-transmit. In this simple form of the
police command, the conform action defaults to transmit and the violate action defaults to drop.
These actions can be set with this command once the style has been configured. Beside, the
set-cos-transmit is to combine only with drop between the conform-action and the violate-action.
<set-cos-transmit> - an priority value is required and is specified as an integer from 0-7.
<set-dscp-transmit> - is required and is specified as either an integer from 0 to 63, or symbolically
through one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41,
af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.
<set-prec-transmit> - an IP Precedence value is required and is specified as an integer from 0-7.
Command Mode
Policy-Class-Map Config
To Next Page
Loading...