Quanta Computer QuantaMesh - Page 63

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
63
5.2.1.7 speed-duplex
This command is used to set the speed and duplex mode for the interface.
The 10-Giga interfaces could be configured to operate at 10-Giga or 1-Giga speed. Use
‘speed-duplex 1000’ to change the speed of 10-Giga port to 1G speed.
The speed of 40-Giga interfaces can not be changed by this command.
Syntax
speed-duplex 1000
no speed-duplex 1000
1000 – 1000 Mbps, only valid for 10G ports.
no - This command will be back to 10G speed from 1G speed on a port.
Default Setting
None
Command Mode
Interface Config
i