Quanta Computer QuantaMesh - Page 656

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
656
MAC Address: The burned in physical address of the specified interface. The format is 6 two-digit
hexadecimal numbers that are separated by colons.
Encapsulation Type: The encapsulation type for the specified interface. The types are: Ethernet or
SNAP.
IP MTU: The maximum transmission unit (MTU) size of a frame, in bytes.
Bandwidth: Shows the bandwidth of the interface.
Destination Unreachables: Displays whether ICMP Destination Unreachables may be sent
(enabled or disabled).
ICMP Redirects: Displays whether ICMP Redirects may be sent (enabled or disabled).
6.2.1.4 show ip interface loopback
This command displays information about configured loopback interfaces.
Syntax
show ip interface loopback [<0-7>]
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Loopback Id: The loopback ID associated with the rest of the information in the row..
Interface: The interface name.
IP Address: The IPv4 address of the interface.
If you specify a loopback ID, the following information appears:
Interface Link Status: Shows whether the link is up or down.
IP Address: The IPv4 address of the interface.
MTU size: The maximum transmission size for packets on this interface, in bytes..