Quanta Computer QuantaMesh - Page 710

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
710
6.3.2.31 default-information originate
default-information originate command is used to control the advertisement of default routes.
no default-information originate command is used to control the advertisement of default routes.
Syntax
default-information originate [always] [metric <0-16777214>] [metric-type {1 | 2}]
no default-information originate [metric] [metric-type]
Default Setting
metric—unspecified
type—2
Command Mode
Router OSPF Config Mode
6.3.2.32 default-metric
default-metric command is used to set a default for the metric of distributed routes.
no default-metric command is used to set a default for the metric of distributed routes.
Syntax
default-metric <1-16777214>
no default-metric
Default Setting
None
Command Mode
Router OSPF Config Mode