Quanta Computer QuantaMesh - Page 740

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
740
6.6.2.9 distribute-list
This command is used to specify the access list to filter routes received from the source protocol. Source
protocols have OSPF, Static, and Connected.
Syntax
distribute-list <1-199> out {ospf | static | connected}
no distribute-list <1-199> out {ospf | static | connected}
<1 - 199> - Access List ID value. The Access List filters the routes to be redistributed by the source
protocol.
no - This command is used to cancel the access list to filter routes received from the source protocol.
Default Setting
0
Command Mode
Router RIP Config