show ip bgp traffic
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
Time Since Counters Cleared: How long ago the SPF ran. The time is in the format hh:mm:ss,
giving the hours, minutes, and seconds since the SPF run.
BGP Message Statistics: The statistics of BGP messages sent/received.
Msgs Sent: Total number of transmitted messages.
Msgs Rcvd: Total number of received messages.
Open: Number of open messages sent and received.
Update: Number of update messages sent and received.
Keepalive: Number of keepalive messages sent and received.
Notification: Number of notification (error) messages sent and received.
Refresh: Number of route refresh request messages sent and received.
Total: Total number of messages sent and received.
Max Received UPDATE rate: Maximum rate of received UPDATE messages.
Max Send UPDATE rate: Maximum rate of sent UPDATE messages.
BGP Queue Statistics: The queue statistics of BGP protocol thread.
Events: Holds configuration events, timer expiration events and TCP status reports.
Keepalive Tx: Keepalive timer event expirations.
Dec Proc: Holds events to trigger one of the 3 phases of the decision proces.
Rx Data: Incoming data.
RTO Notifications: RTO notifications. Redistributed routes and next hop resolution changes.
MIB Queries: BGP MIB path queries.
Current: Number of messages in queue currently.
Max: Maximum number of messages in queue.
Drops: Number of messages dropped.
Limit: Maximum size of queue.
To Next Page
Loading...