Quanta Computer QuantaMesh - Page 802

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
802
6.11.2.9 bgp log-neighbor-changes
This command enable logging of BGP neighbor resets . To disable the logging of changes in BGP
neighbor adjacencies, use the no form of this command.
Syntax
bgp log-neighbor-changes
no bgp log-neighbor-changes
Default Setting
Disabled
Command Mode
Router BGP Config Mode
6.11.2.10 bgp router-id
This command sets a 4-digit dotted-decimal number uniquely identifying the router bgp id. The
<router-id> is a configured value.
Syntax
bgp <router-id>
no bgp <router-id>
Default Setting
None
Command Mode
Router BGP Config Mode
6.11.2.11 bgp maxas-limit
This command configures Border Gateway Protocol (BGP) to discard routes that have a number of
autonomous system numbers in AS-path that exceed the specified value. To return the router to default
operation, use the no form of this command.
Syntax
bgp maxas-limit <number>
no bgp maxas-limit