Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
6.11.2.16 neighbor update-source
This command is used to allow BGP sessions to use any operational interface for TCP connections, use
the neighbor update-source command in Router BGP Config Mode. To restore the interface assignment
to the closest interface, which is called the best local address, use the no form of this command.
Syntax
neighbor <peeripaddr> update-source {<slot/port> | loop <loop interface number>}
no neighbor <peeripaddr> update-source
peeripaddr: IP address of the neighboring router.
slot/port: Valid slot and port number separated by forward slashes.
loop interface number: The valid value is 0 to 7.
Default Setting
None
Command Mode
Router BGP Config Mode
6.11.2.17 neighbor description
This command is used to associate a description with a neighbor, use the neighbor description
command in router configuration mode. To remove the description, use the no form of this command.
Syntax
neighbor <peeripaddr> description <description>
no neighbor <peeripaddr> description <description>
peeripaddr: IP address of the neighboring router.
description: Text (up to 80 characters) that describes the neighbor
Default Setting
None
Command Mode
Router BGP Config Mode
To Next Page
Loading...