Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands
7.2.2.8 ip igmp robustness
This command configures the robustness that allows tuning of the interface. The robustness is the tuning
for the expected packet loss on a subnet. If a subnet is expected to have a lot of loss, the Robustness
variable may be increased for the interface.
Syntax
ip igmp robustness <1-255>
no ip igmp robustness
<1-255> - The range for <1-255> is 1 to 255.
no - This command sets the robustness value to default.
Default Setting
2
Command Mode
Interface Config
7.2.2.9 ip igmp startup-query-count
This command sets the number of Queries sent out on startup, separated by the Startup Query Interval
on the interface.
Syntax
ip igmp startup-query-count <1-20>
no ip igmp startup-query-count
<1-20> - The range for <1-20> is 1 to 20.
no - This command resets the number of Queries sent out on startup, separated by the Startup
Query Interval on the interface to the default value.
Default Setting
2
Command Mode
Interface Config
To Next Page
Loading...