show ipv6 mld interface [{<slot/port> | vlan <vlan-id>}]
<slot/port> - Valid slot and port number separated by forward slashes.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec
Display Message
The following information is displayed for each of the interfaces or for only the specified interface.
Interface: The interface number in slot/port format.
MLD Global Admin Mode: Displays the configured administrative status of MLD.
MLD Interface Admin Mode: Displays the configured administrative status of MLD on the interface.
MLD Operational Mode: The operational status of MLD on the interface.
MLD Version: Indicates the version of MLD configured on the interface.
Query Interval: Indicates the configured query interval for the interface.
Query Max Response Time: Indicates the configured maximum query response time (in seconds)
advertised in MLD queries on this interface.
Robustness: Displays the configured value for the tuning for the expected packet loss on a subnet
attached to the interface.
Startup Query interval: This valued indicates the configured interval between General Queries sent
by a Querier on startup.
Startup Query Count: This value indicates the configured number of Queries sent out on startup,
separated by the Startup Query Interval.
Last Member Query Interval: This value indicates the configured Maximum Response Time
inserted into Group-Specific Queries sent in response to Leave Group messages.
Last Member Query Count: This value indicates the configured number of Group-Specific Queries
sent before the router assumes that there are no local members.
The following information is displayed if the operational mode of the MLD interface is enabled.
Querier Status: This value indicates whether the interface is an MLD querier or non-querier on the
subnet it is associated with.
To Next Page
Loading...