7.5.1.3 show ip pim interface
This command displays the interface information for PIM on the specified interface. If no interface is
specified, the command displays the status parameters for all PIM-enabled interfaces.
Syntax
show ip pim interface [{<slot/port> | vlan <vlan-id>}]
<slot/port> - Interface number.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
Interface: slot/port
Mode: Indicates whether the PIM mode enabled on the interface is dense or sparse
Hello Interval: The frequency at which PIM hello messages are transmitted on this interface. By
default, the value is 30 seconds
Join Prune Interval: The join/prune interval for the PIM router. The interval is in seconds
DR Priority: The priority of the Designated Router configured on the interface. This field is not
applicable if the interface mode is Dense
BSR Border: Identifies whether this interface is configured as a bootstrap router border interface
Neighbor Count: The number of PIM neighbors learned on this interface. This is a dynamic value
and is shown only when a PIM interface is operational
Designated Router: The IP address of the elected Designated Router for this interface. This is a
dynamic value and will only be shown when a PIM interface is operational. This field is not applicable
if the interface mode is Dense
To Next Page
Loading...